It’s time to upgrade your auger bit, using this repair hub by Titan. This repair hub will help make your auger a bit stronger and sturdier. No longer will you need to worry about it bending or bowing under pressure because our repair hub is made from the most tenacious materials available. It’s constructed from cast alloy, so it is sure to last for a good long while. Typically, when a hex hub fails, it wears along the straight line. With its ergonomic design, our repair hub reduces the stresses that occur during drilling. This, in turn, allows for an overall stronger drive. This repair hub is a 2-inch female hex. It can be welded to any standard auger bit and is compatible with any 2-inch hex drive shaft that has 3/4" or 5/8" pin holes. This repair hub measures 8” in length and has a diameter of 3 1/2”. It weighs about 11 lbs., making it a lightweight piece of equipment. This heavy-duty forged repair hub will make the perfect addition to your toolbox. Order this repair hub from Titan today as a replacement for your weak and feeble hubs.
REPAIR YOUR HUB: A failed hub usually breaks along the straight line due to excessive stress or poor construction. Our repair hub helps reduce the stress that occurs during drilling, making for a much stronger drive overall. Use it to fix your worn or broken hex hub connections for your auger or extension.
FEMALE CONNECTOR: This repair hub set is designed to receive any 2-inch hex drive shaft. It is compatible with either 5/8" or 3/4" pin holes. This repair hub makes up the female component, so it will connect to male pieces of hardware. It can make a useful and helpful tool in your toolbox. Add it to your tool kit supplies and accessories today!
STRONG STURDY CONSTRUCTION: At Titan, we don’t mess around when it comes to making high-quality products, and this repair hub is no exception. Using expert craftsmanship and superior materials, this repair hub offers the best quality possible. It’s made from cast alloy, making it a strong and durable piece of hardware.
EASY INSTALLATION: Our repair hub is designed for welding onto 2-inch industrial tubing. With its multi-hole design, installing the repair hub is a piece of cake. Simply pull out your welding supplies and get to work. In no time, you’ll have an upgraded auger bit that will last you for years to come.
SPECIFICATIONS: This repair hub kit weighs approximately 11 lbs. It has an overall length of 8” and a diameter of 3 1/2”. The pin holes measure 3/4" and 5/8" in diameter. The receiver shaft is 1/2" thick, making for an exceptionally sturdy construction that is sure to last for a long time. Finally, you can repair or upgrade your auger bit with this cast alloy hub.
- Cast alloy hub
- Can be welded to any standard auger bit
- 1/2” thick cast alloy receiver shaft
- 3/4” or 5/8” pin holes
- Size: 2” hex female
- Pin Holes: 3/4” and 5/8”
- 8” overall length
- 3.5” diameter
- Weight: 11 lb
This equipment must be used with care by capable and competent individuals under supervision, if necessary. The use of any equipment, including this one, involves the potential risk of injury. You accept and assume full responsibility for any and all injuries, damages (both economic and non-economic), and losses of any type, which may occur, and you fully and forever release and discharge Titan, its insurers, employees, officers, directors, associates, and agents from any and all claims, demands, damages, rights of action, or causes of action, present or future, whether the same be known or unknown, anticipated, or unanticipated, resulting from or arising out of the use of said equipment.
TITAN MAKES NO WARRANTY WHATSOEVER WITH RESPECT TO THE EQUIPMENT, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, WHETHER EXPRESS OR IMPLIED BY LAW, COURSE OF DEALING, COURSE OF PERFORMANCE, USAGE OF TRADE OR OTHERWISE. BUYER ASSUMES ALL LIABILITY IN USE OF THE EQUIPMENT.